Wavy decorate ribs shelf

In stock · Made-to-order resin · Ships from Auckland · Free shipping over $75

Material

PLA (filament)

Colour

Grey

Weight

~40 g

Print time

~4.5 h

Shipping

$10 std · $20 express

Lead time

1-3 d print + 1-4 d ship

The wavy decorate shelf is 71cm wide (28in) and can hold up to 5Kg securely. Installation notes: 1. All 6 pieces has their part name engraved in the back 2. Start with the ‘left bottom’ part 3. Connect ‘left middle’ and ‘left right’ parts using the small clip at the back 4. Do not be concerned from the clip doesn’t hold the pieces steadily, everything will be secured once fully assembled and placed on a wall 5. Place the 3 connected bottom parts against the target location on the wall 6. Using a pen (ideally just the infill of a pen to mark through the narrow holes) mark on the wall the 3 points against the 3 holes of the shelf 7. Drill 3 holes and place 3 plastic wall plugs (I was drilling 8mm holes for 8 mm plugs) 8. Secure the bottom pieces to the wall with 3 screws 9. Connect the 3 upper parts from left to right using the clip 10. Slide the 3 top parts on top of the wall secured 3 bottom parts using the set of rails on each shelf rib - this might require some little pushes in each side to slide it all the way properly 11. That’s it!